Next: , Up: Plotting   [Contents][Index]


15.1 Introduction to Plotting

Earlier versions of Octave provided plotting through the use of gnuplot. This capability is still available. But, newer versions of Octave offer more modern plotting capabilities using OpenGL. Which plotting system is used is controlled by the graphics_toolkit function. See Graphics Toolkits.

The function call graphics_toolkit ("qt") selects the Qt/OpenGL system, graphics_toolkit ("fltk") selects the FLTK/OpenGL system, and graphics_toolkit ("gnuplot") selects the gnuplot system. The three systems may be used selectively through the use of the graphics_toolkit property of the graphics handle for each figure. This is explained in Graphics Data Structures.

Caution: The OpenGL-based toolkits use single precision variables internally which limits the maximum value that can be displayed to approximately 10^{38}. If your data contains larger values you must use the gnuplot toolkit which supports values up to 10^{308}. Similarly, single precision variables can accurately represent only 6-9 base10 digits. If your data contains very fine differences (approximately 1e-8) these cannot be resolved with the OpenGL-based graphics toolkits and the gnuplot toolkit is required.

Note: The gnuplot graphics toolkit uses the third party program gnuplot for plotting. The communication from Octave to gnuplot is done via a one-way pipe. This has implications for performance and functionality. Performance is significantly slower because the entire data set, which could be many megabytes, must be passed to gnuplot over the pipe. Functionality is negatively affected because the pipe is one-way from Octave to gnuplot. Octave has no way of knowing about user interactions with the plot window (be it resizing, moving, closing, or anything else). It is recommended not to interact with (or close) a gnuplot window if you will access the figure from Octave later on.


Next: High-Level Plotting, Up: Plotting   [Contents][Index]